Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
- 7. Transmissions
   - 7.1. Mechanical transmission
      7.1.1. Introduction
      7.1.2. Technical characteristics
      7.1.3. Lever, casing of the lever and gear shifting mechanism
      7.1.4. Switch of fires of lamps of a backing
      7.1.5. Removal and MKPP installation
   + 7.2. Automatic transmission
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


дешевые душевые перегородки

7.1.5. Removal and MKPP installation
GENERAL INFORMATION

Arrangement of bolts of a transmission and engine (4-cylinder models)

  

Arrangement of bolts of a transmission and engine (6-cylinder models)

Removal

PERFORMANCE ORDER
1. Lower pressure in fuel system. Disconnect a wire of the minus plug of the accumulator and remove the accumulator together with an arm.
2. Remove an airintaking branch pipe and the air filter.
3. Remove a starter.
4. Disconnect wires from a transmission.
5. Include a reverse gear.
6. Disconnect from a transmission switching rod and extending core.
7. Disconnect a wire from the sensor of speed of the car.
8. Disconnect press the cylinder of coupling and fix it a wire slice.
9. Lift and fix a forward part of the car. Fix the engine on the lift.
10. Unscrew the top bolts, fixing a transmission to the engine.
11. Remove the fuel filter.
12. Remove the left support of the engine.
13. Lift and fix a forward part of the car. Remove forward wheels.
14. Merge transmission oil.
15. In four-cylinder engines unscrew bolts (And) an arm of an inlet collector (bolts (In) fix a starter arm) and remove an arm.
16. Remove final system.
17. Remove semi-axes and an intermediate shaft.
18. Insert plugs or special caps into openings of semi-axes.
19. Fix plugs a sticky tape that they did not fall out when you will remove a transmission.
20. Remove protective guards and a cross-piece.
21. Unscrew six bolts, braid two nuts and remove a transmission support.
22. Unscrew bolts (shooters) and uncover couplings.
23. Establish a jack under a transmission.
24. Unscrew the remained bolts of a transmission.
25. In 4-cylinder engines unscrew bolts (shooters) and disconnect a transmission and engine arm.

26. Disconnect a transmission from the engine and lower it on a jack.

Installation

Installation of a transmission is carried out upside-down removals.