Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
- 10. Running gear
   10.1. Introduction
   10.2. Technical characteristics
   - 10.3. Suspension brackets
      + 10.3.1. Rack of a forward suspension bracket
      - 10.3.2. Rack of a back suspension bracket
         10.3.2.1. Arm of a nave of a back wheel
         10.3.2.2. Nave and bearing of a nave of a back wheel
         10.3.2.3. Stabilizer of cross-section stability of a back suspension bracket
         10.3.2.4. Lever of a back suspension bracket
      10.3.3. Size of tires
      10.3.4. Corners of installation of wheels
   + 10.4. Steering
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


Советы по удалению пятен на вес золота

10.3.2.4. Lever of a back suspension bracket

Removal and installation

PERFORMANCE ORDER
1. Remove back wheels.
Cross-section levers
Forward lever
2. Turn off and remove a through bolt (it is specified by shooters), fixing levers to a nave arm.
3. Remove caps from a cross-piece of a back suspension bracket.
4. Turn off nuts of fastening of the internal ends of cross-section levers (are specified by shooters).
5. Mark the provision of installation of a cross-piece on the car bottom.
6. Establish a jack under a cross-piece, turn off fixing bolts and lower a cross-piece. Remove internal sharnirny bolts and remove the suspension bracket lever.
7. Installation is carried out upside-down removals.
Back levers
8. Disconnect connecting draft of the stabilizer of cross-section stability from the back cross-section lever.
9. Turn off the through bolt, fixing the external ends of cross-section levers to a nave arm.
10. Mark the provision of installation of adjusting cams. Turn off internal fixing nuts and remove the back cross-section lever of a suspension bracket.
11. Installation is carried out upside-down removals.
Longitudinal levers
12. Remove a rope of the hand brake from the suspension bracket lever.
13. Turn off a bolt of fastening of the lever to a nave arm.
14. Turn off a sharnirny bolt and remove the longitudinal lever of a suspension bracket.
15. Installation is carried out upside-down removals.