Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
- 5. Fuel system
   + 5.1. Nikki 30/34 carburetor
   - 5.2. Power supply system (l engines 1,6 and 1,8)
      5.2.1. Introduction
      5.2.2. Technical characteristics
      5.2.3. Pressure release from a power supply system
      5.2.4. Fuel pump / pressure in a power supply system
      5.2.5. Fuel tubes and connections
      5.2.6. Removal and installation of the fuel pump
      5.2.7. Fuel level sensor
      5.2.8. Fuel tank
      5.2.9. Air filter
      5.2.10. Accelerator rope
      + 5.2.11. System of electronic injection of fuel
   + 5.3. Power supply system (l engines 2,0 and 2,5)
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


5.2.7. Fuel level sensor

GENERAL INFORMATION

Resistance at the lowered lever of a float (the fuel tank is empty)

Resistance at the lowered lever of a float should be about 110 Ohm.

Resistance at the lifted lever of a float (the fuel tank is full)

Resistance at the lifted lever of a float should be about 2-4 Ohms.

Check

PERFORMANCE ORDER
1. Cнимите the fuel pump also check, that resistance of the sensor smoothly changed when lowering float from 110 Ohm to about 2-4 Ohm.
2. Replace the sensor if it is necessary.

Replacement

PERFORMANCE ORDER
1. Disconnect the connection socket.
2. Turn off a fixing nut and remove the sensor.
3. Installation is carried out upside-down removals.