Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and body repair
   11.3. Vinyl furnish
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and neostarting-up glasses
   11.8. Replacement front grilles (Mazda 626 model)
   11.9. Cowl
   11.10. Bumpers - removal and installation
   11.11. Forward wing
   11.12. The plastic panel before a windshield
   11.13. Panel of furnish of a door
   11.14. Doors
   11.15. Door lock, drum of the lock and handle
   11.16. Door glass
   11.17. Window regulator mechanism
   11.18. Rear-view mirrors
   11.19. Trunk lid (Mazda 626 and MX-6 models)
   11.20. Lock and drum of the lock of a trunk lid (Mazda 626 and MX-6 model)
   11.21. Ropes of opening of a cover of a luggage carrier / zaslonka of a fuel tank
   11.22. Back door (Ford Probe models)
   11.23. Lock of a back door and drum of the lock (Ford Probe model)
   11.24. Basic racks of a back door / trunk lid (model Ford Probe, MX-6)
   11.25. Central console
   11.26. Panels of furnish of the dashboard
   11.27. Casing of a steering column
   11.28. Dashboard
   11.29. Sitting
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice






11.18. Rear-view mirrors

Removal and installation

PERFORMANCE ORDER
External rear-view mirrors
1. On models with the electric drive of rear-view mirrors remove the panel of furnish of a door.
2. Remove the lateral panel.
4. Disconnect the socket of connection of a mirror (And), turn off fixing screws (are specified by shooters) and remove a mirror.
5. Installation is carried out upside-down removals.
Internal rear-view mirror
Models till 1997 of release:
6. Turn off the fixing screw and remove a mirror from fastening.
7. Installation is carried out upside-down removals.
Models since 1998 of release:
8. Insert a thin screw-driver into fastening of a mirror and release a fixing clip. Remove a mirror.
9. At installation insert a mirror into fastening and check, that the latch fixed a mirror.