Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and body repair
   11.3. Vinyl furnish
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and neostarting-up glasses
   11.8. Replacement front grilles (Mazda 626 model)
   11.9. Cowl
   11.10. Bumpers - removal and installation
   11.11. Forward wing
   11.12. The plastic panel before a windshield
   11.13. Panel of furnish of a door
   11.14. Doors
   11.15. Door lock, drum of the lock and handle
   11.16. Door glass
   11.17. Window regulator mechanism
   11.18. Rear-view mirrors
   11.19. Trunk lid (Mazda 626 and MX-6 models)
   11.20. Lock and drum of the lock of a trunk lid (Mazda 626 and MX-6 model)
   11.21. Ropes of opening of a cover of a luggage carrier / zaslonka of a fuel tank
   11.22. Back door (Ford Probe models)
   11.23. Lock of a back door and drum of the lock (Ford Probe model)
   11.24. Basic racks of a back door / trunk lid (model Ford Probe, MX-6)
   11.25. Central console
   11.26. Panels of furnish of the dashboard
   11.27. Casing of a steering column
   11.28. Dashboard
   11.29. Sitting
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


11.25. Central console

Removal and installation

PERFORMANCE ORDER
1. Disconnect the accumulator.
2. Remove the forward panel from the central console.
3. Remove a casing of the lever of gear shifting.

4. Remove a casing of the lever of the hand brake.

5. Turn off fixing screws (are specified by shooters) and remove the central shelf.
6. Turn off the screws, fixing the console to a floor (are specified by shooters).

7. Turn off back fixing screws (are specified by shooters).
8. Turn off fixing screws (are specified by shooters) on a forward edge of the console.

9. Turn off lateral fixing screws (are specified by shooters) and remove the central console. Disconnect connection sockets.
10. Installation is carried out upside-down removals.