|
|
Mazda 6261991-1998 of releaseRepair and car operation |
|
|
Mazda 626 - 1. Maintenance instruction 1.1. Interior review 1.2. Dashboard review 1.3. Information plates of the car 1.4. Automatic inclusion of transfers 1.5. Councils on driving 1.6. Dashboard + 1.7. Warning sound / light signals, headlights 1.8. Screen wiper and windscreen washer 1.9. Screen wiper and washer of back glass 1.10. Washer of headlights 1.11. Anti-icer of back glass 1.12. Flight computer 1.13. Display of external temperature 1.14. Hours 1.15. Types of central air of air 1.16. Safety locks 1.17. Identification number of the car + 2. Maintenance + 3. Engines + 4. Heating and ventilation + 5. Fuel system + 6. Exhaust system + 7. Transmissions + 8. Coupling and semi-axes + 9. Brake system + 10. Running gear + 11. Body + 12. Electric equipment + 13. Electroschemes + 14. Good advice Гимнастика |
1.16. Safety locks
The electric system of your car is protected by fuses.
If any elements of lighting, accessory or governing bodies do not work, examine a safety lock of the corresponding chain. If it fused, its melted thread will be visible. If the same safety lock fuses repeatedly, avoid use of this system and as soon as possible address at the authorized dealer of Mazda firm.
Standard safety lock
Replacement of safety locks 1. Switch off ignition and other electric chains. 2. Open the panel of safety locks. 3. Pull out a safety lock, using a stripper located on the panel of safety locks. 4. Examine a safety lock and if it fused, replace it new. 5. Insert a new safety lock with the same face values and track, that it reliably rose on the place. If so it is impossible, address to the authorized dealer of Mazda firm for performance of this operation. If you have near at hand no spare safety locks, borrow a safety lock from a chain which is not representing to critical importance for operation of the car, for example, from radio system. Prevention
If headlights or other electric components do not work, and all safety locks in a cabin are whole, examine the block of safety locks under a cowl. Execute the following procedures: 1. Switch off ignition and other electric chains. 2. For removal of a cover of the block of safety locks remove it from a clamp and pull it up from a ledge. 3. If the safety lock fused, replace it new, with the same face values. Main safety lock
Replacement of a safety lock on 100 And
1. Check, that ignition was switched off. 2. Disconnect the negative plug of the accumulator. 3. Turn off nuts And. 4. Lift the block of switches and unscrew bolts of Century. 5. Replace a safety lock new, with the same face value. 6. Execute procedures upside-down for return of the car to a working condition. Block of safety locks (motor compartment)
Panel of safety locks
Block of safety locks (motor compartment)
|
|