Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
- 8. Coupling and semi-axes
   8.1. Introduction
   8.2. Technical characteristics
   - 8.3. Coupling
      8.3.1. Cylinders of a drive of switching off of coupling
      8.3.2. Hydraulic system of a drive of switching off of coupling
      8.3.3. Elements of the mechanism of coupling
      8.3.4. Vyzhimna bearing and fork of the vyzhimny bearing
      8.3.5. Adjustment of a pedal of coupling
      8.3.6. Blocking switch
   + 8.4. Semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice



8.3.3. Elements of the mechanism of coupling

GENERAL INFORMATION

Wear of a press disk

1. Normal wear of plates of a spring
2. Excessive wear
3. Excessive wear of plates of a spring
4. The broken or pognuty plates

Coupling disk

1. Frictional material

2. Springs

3. Nave

4. Rivets

Removal

PERFORMANCE ORDER
1. Remove a transmission.
2. Mark the provision of installation of a press disk on a flywheel.
3. Gradually in a diagonal order turn off fixing bolts (shooters) and remove press a disk and a coupling disk.

Survey

PERFORMANCE ORDER
1. Examine a flywheel on existence of cracks, traces of an overheat, flutes or other damages.
2. Examine a surface of a disk of coupling on existence of cracks, deformation and other damages. Check a condition of rivets and springs.
3. Check a condition of a diafragmenny spring and a press disk on existence of scratches, cracks and overheat traces.
4. Examine the bearing on the end of a cranked shaft on existence of wear, scratches or other damages.
5. Remove the bearing.

Installation

PERFORMANCE ORDER
1. Establish the new directing bearing by means of an opravka.
2. Establish a disk of coupling and press a disk on a flywheel, holding a coupling disk by means of the adjusting tool.
3. Slightly twirl fixing bolts of a press disk.
4. By means of the adjusting tool adjust the provision of a disk of coupling and gradually in a diagonal order tighten fixing bolts of a press disk till the demanded moment of an inhaling.
5. Grease an internal flute of the vyzhimny bearing and establish it into place.
6. Establish a transmission on the car.