Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
- 8. Coupling and semi-axes
   8.1. Introduction
   8.2. Technical characteristics
   - 8.3. Coupling
      8.3.1. Cylinders of a drive of switching off of coupling
      8.3.2. Hydraulic system of a drive of switching off of coupling
      8.3.3. Elements of the mechanism of coupling
      8.3.4. Vyzhimna bearing and fork of the vyzhimny bearing
      8.3.5. Adjustment of a pedal of coupling
      8.3.6. Blocking switch
   + 8.4. Semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

8.3.6. Blocking switch


Sockets of connection of the blocking switch

1. 3-штырьковый I will corrode connections

2. 5-штырьковый I will corrode connections


Check, that the switch closed a chain by pressing a coupling pedal. Thus between plugs 1 and 2 of the socket of connection there should be a conductivity. When the pedal is released, the switch should disconnect a chain. Adjust or replace the switch if it is necessary.


1. Disconnect the socket of connection of the switch. Further, depending on model, turn the switch on 90 ° and remove it from a fixing arm or turn off two fixing screws and remove the switch.
2. Installation is carried out upside-down removals.


Turn off fixing nuts and change position of the switch as it is necessary. Tighten fixing nuts.