Mazda 626
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
- 12. Electric equipment
12.1. Introduction
12.2. Search of a source of malfunction in electric equipment system
12.3. Safety locks
12.4. Automatic switches
12.5. Relay
12.6. Breaker of indexes of turns / alarm system
12.7. Switches on a steering column
12.8. Switch of ignition and lock drum
12.9. Switches on the dashboard
12.10. Tools of an instrument guard
12.11. Instrument guard
12.12. Radio receiver and loudspeakers
12.13. Aerial
12.14. Bulbs of headlights of head light
12.15. Headlights of head light
12.16. Drive of headlights of head light
12.17. Replacement of bulbs
12.18. Engine of screen wipers
12.19. Horn of a sound signal
12.20. System of day inclusion of headlights
12.21. Heater of back glass
12.22. System cruise control
12.23. Electric window regulators
12.24. Central lock and remote control by the central lock
12.25. A rear-view mirror with the electric drive
12.26. Top hatch
12.27. Safety airbag
+ 13. Electroschemes
+ 14. Good advice
|
|
|
For adjustment of provision of headlights of head light two adjusting screws are provided. |
Scheme of adjustment of headlights of head light
|
|
Adjust headlights of head light, using the provided scheme. At adjustment of a passing beam the center of a zone of high illumination should be lower approximately on 5 cm and more to the right перекрестья than lines. |
Replacement
Mazda models
| PERFORMANCE ORDER |
| 1. Disconnect sockets of connection and remove bulbs. |
| 2. Remove a front grille. |
|
|
3. Remove the index of turns if it is necessary, turn off fixing bolts (are specified by shooters) and remove a headlight. |
| 4. Installation is carried out upside-down removals. |
|
Ford Probe models
| PERFORMANCE ORDER |
| 1. Disconnect a wire of the minus plug of the accumulator. |
|
|
| 2. Turn off fixing bolts (a photo at the left) and nuts (a photo on the right) headlights, disconnect the connection socket. |
| |
3. Disconnect the lever (And) from the lift mechanism (In). Remove a headlight. |
| 4. Installation is carried out upside-down removals. |
|
|
|