Mazda 626
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. Petrol engines (1,6 and 1,8 liters)
- 3.2. Petrol 4-cylinder engine (2 liters)
3.2.1. Introduction
3.2.2. Technical characteristics
3.2.3. Recommendations about repair
3.2.4. Top dead point
3.2.5. Cover of a head of cylinders
3.2.6. Springs, clamps and epiploons of valves
3.2.7. Gas-distributing belt and asterisks
3.2.8. Camshafts and pushers
3.2.9. Inlet collector
3.2.10. Final collector
3.2.11. Head of cylinders
3.2.12. Forward epiploon of a cranked shaft
3.2.13. Oil pallet
3.2.14. Oil pump
3.2.15. Flywheel or leading disk
3.2.16. Back epiploon of a cranked shaft
3.2.17. Engine fastenings
+ 3.3. Petrol V6 engine (2,5 liters)
+ 3.4. Partition of engines (1,6 and 1,8 liters)
+ 3.5. Partition of engines (2,0 and 2,5 liters of V6)
+ 3.6. Diesel engine of 2,0 liters
+ 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice
|
Removal
| PERFORMANCE ORDER |
| 1. Disconnect a wire of the minus plug of the accumulator. |
| 2. Lift and fix a forward part of the car. |
| 3. Remove the bottom guard of the engine. |
| 4. Merge engine oil and remove the oil filter. |
| 5. Get щуп for measurement of level of oil. |
| 6. Disconnect a wire from the oxygen sensor. Disconnect an exhaust pipe from a final collector and lower a pipe together with the catalytic converter. |
| 7. Unscrew bolts and remove the oil pallet. |
|
Installation
| PERFORMANCE ORDER |
| 1. Carefully clean and wipe solvent or acetone being joined surfaces of the pallet and the block of cylinders. |
| 2. Clean openings of bolts in the block of cylinders. |
| 3. Examine the oil pallet on existence of cracks and other damages. If you removed a maslozaborny branch pipe, establish a new sealing ring. |
| 4. Put hermetic on a flange of the oil pallet. |
| 5. Establish the pallet and tighten bolts. |
| 6. Establish the remained details, get the engine and check the oil pallet on existence of leaks. |
|
|
|