Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   - 3.2. Petrol 4-cylinder engine (2 liters)
      3.2.1. Introduction
      3.2.2. Technical characteristics
      3.2.3. Recommendations about repair
      3.2.4. Top dead point
      3.2.5. Cover of a head of cylinders
      3.2.6. Springs, clamps and epiploons of valves
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Camshafts and pushers
      3.2.9. Inlet collector
      3.2.10. Final collector
      3.2.11. Head of cylinders
      3.2.12. Forward epiploon of a cranked shaft
      3.2.13. Oil pallet
      3.2.14. Oil pump
      3.2.15. Flywheel or leading disk
      3.2.16. Back epiploon of a cranked shaft
      3.2.17. Engine fastenings
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

3.2.6. Springs, clamps and epiploons of valves

GENERAL INFORMATION

Valve elements

And – the Valve

B–Epiploon of a rod of the valve

C–Valve spring

D–Plate of a spring

E–Clamps

Replacement

PERFORMANCE ORDER

1. Remove a camshaft. Get pushers of faulty valves.
2. Unscrew candles of cylinders which faulty valves concern.
3. Establish the piston of the cylinder necessary to you in VMT.
	4. Twist an adapter in an opening of a spark plug and connect to an adapter a hose of the air compressor.
5. Turn on the compressor.
	6. By means of the special tool compress a spring of the valve and remove clamps.
7. Remove a plate of a spring, a spring and a spring saddle. If at carrying out this procedure the compressed air in the cylinder does not hold the valve in the closed condition, means, the facet of the valve and / or a valve saddle is damaged.
	8. Measure depth of landing of an epiploon of a rod of the valve and remove an epiploon.
9. Examine a valve spring on existence of cracks and other damages. Measure length of a spring and compare it to technical requirements (see subsection 3.2.2).
	10. Grease a valve rod with engine oil and establish a new epiploon, using the special tool or the suitable plug.
Prevention Do not mix epiploons of inlet and final valves. Epiploons of final valves have ledges in the top part.
11. Establish a saddle of a spring and a valve spring.
	12. Establish a plate of a spring. Compress a spring and establish clamps, if necessary put on clamps a small amount of hermetic.
13. Disconnect a hose of the compressor and unscrew an adapter.
14. Establish all remained details, get the engine and check a head of cylinders on existence of leaks and unusual sounds.