Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   - 3.2. Petrol 4-cylinder engine (2 liters)
      3.2.1. Introduction
      3.2.2. Technical characteristics
      3.2.3. Recommendations about repair
      3.2.4. Top dead point
      3.2.5. Cover of a head of cylinders
      3.2.6. Springs, clamps and epiploons of valves
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Camshafts and pushers
      3.2.9. Inlet collector
      3.2.10. Final collector
      3.2.11. Head of cylinders
      3.2.12. Forward epiploon of a cranked shaft
      3.2.13. Oil pallet
      3.2.14. Oil pump
      3.2.15. Flywheel or leading disk
      3.2.16. Back epiploon of a cranked shaft
      3.2.17. Engine fastenings
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


3.2.9. Inlet collector

Removal

PERFORMANCE ORDER
1. Lower pressure in fuel system.
2. Disconnect a wire of the minus plug of the accumulator.
3. Merge cooling liquid.
4. Remove an airintaking branch pipe. Disconnect from the throttle case an accelerator rope, hoses and wires.
5. Disconnect a plait of wires, ropes of management and hoses from an inlet collector.
6. Disconnect wires from fuel injectors. Disconnect tubes of supply of fuel from the fuel highway.
7. Disconnect a tube and the valve of system of a retsirkulyatsiya of exhaust gases.
8. Unscrew bolts of a basic arm and remove a support of an inlet collector.
9. Disconnect hoses (And), unscrew a bolt (In) a hose arm, unscrew bolts and nuts (C) an inlet collector.
10. Remove an inlet collector.

Installation

PERFORMANCE ORDER
1. Clean off the remains of old laying from being joined surfaces of a collector and a head of cylinders. Clean surfaces solvent.
2. Establish new laying, establish a collector and insert bolts.
3. Tighten bolts and collector nuts in the specified sequence.
4. Establish the remained details. Get the engine and check it on existence of leaks. Check, whether all systems of the engine correctly function.