Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   - 3.7. Systems of electric equipment of the engine
      3.7.1. Introduction
      3.7.2. Technical characteristics
      3.7.3. Accumulator
      + 3.7.4. Ignition system
      3.7.5. System of additional charge of the accumulator
      3.7.6. Generator
      + 3.7.7. Starter and system of start of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

3.7.3. Accumulator

Check

PERFORMANCE ORDER

Accumulator

1. Disconnect a wire of the minus plug of the accumulator, and then a wire of the plusovy plug.

2. Check battery charging degree.

3. Check, that when giving load of the accumulator, tension did not fall below 9,6 Volts.

Wires of connection of the accumulator

4. Periodically examine wires of connection of the accumulator on all length on existence of damages, cracks or corrosion.

5. Clear contacts of wires of corrosion if it is necessary.

Replacement

PERFORMANCE ORDER

Accumulator

1. Disconnect a wire of the minus plug of the accumulator, and then a wire of the plusovy plug. Remove a fixing level of the accumulator (it is specified by an arrow).

2. Remove the accumulator.

3. Turn off fixing bolts and remove the storage shelf. Clear the shelf of corrosion if it is necessary.

4. Installation of the new accumulator is carried out upside-down removals.

Wires of connection of the accumulator

5. At a detachment of wires the first always disconnect a wire of the minus plug of the accumulator.

6. Turn off nuts of clips and disconnect wires from the accumulator.

7. Get wires from fixing clips (it is specified by an arrow).

8. The wire of the minus plug of the accumulator fastens to an arm in an impellent compartment (it is specified by an arrow a photo at the left) and to a transmission (fastening is specified by an arrow a photo on the right).

9. The wire of the plusovy plug of the accumulator is connected to a starter (it is specified by an arrow a photo at the left) and the block of safety locks / relay (connection is specified by an arrow a photo on the right) in an impellent compartment.

10. Clear contacts and establish new wires.