Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   - 3.7. Systems of electric equipment of the engine
      3.7.1. Introduction
      3.7.2. Technical characteristics
      3.7.3. Accumulator
      + 3.7.4. Ignition system
      3.7.5. System of additional charge of the accumulator
      3.7.6. Generator
      - 3.7.7. Starter and system of start of the engine
         3.7.7.1. The involving relay of a starter
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


3.7.7. Starter and system of start of the engine

GENERAL INFORMATION

The system of start of the engine consists of the accumulator, a starter involving the relay and connecting wires. The involving relay is located on a starter.

At work with system of start of the engine observe the precautionary measures provided for work with system of electric equipment of the engine.

Work check a starter and the involving relay
1. The involving relay

2. Starter

3. Vice

4. Ignition lock

Check
PERFORMANCE ORDER
1. First of all, check connecting wires and reliability of connections. Check a battery charging. Check reliability of fastening of a starter. Check safety locks and the blocking switch on a transmission.
2. If the starter rotates slowly, check tension giving on a starter. It should not fall below 8,0 Volts.
3. If the starter supply voltage as it should be, however, a starter does not work, remove a starter and check operation of the involving relay. Replace a starter or the relay if it is necessary.

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the air filter and an airintaking branch pipe.
Models with the 4-cylinder engine
3. Remove an arm located between an inlet collector and a starter.
Models with the 6-cylinder engine and an automatic transmission
4. Disconnect a switching rope from the lever on a transmission.
5. Disconnect sockets of connection of the wires disturbing to removal of a starter, and remove wires aside.
6. Remove a fixing arm of a rope of gear shifting.
All models
7. Mark and disconnect wires from plugs on the starter relay. Turn off fixing bolts (are specified by shooters) and remove a starter (at the left – models with the 4-cylinder engine, on the right – models with the 6-cylinder engine).
8. Installation is carried out upside-down removals.