Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
- 6. Exhaust system
   + 6.1. Exhaust system
   - 6.2. Systems of decrease in toxicity of exhausts and management of operation of the engine
      6.2.1. Introduction
      6.2.2. System of self-diagnostics and malfunction codes
      6.2.3. Central control unit
      6.2.4. Sensor of provision of a butterfly valve
      6.2.5. Sensor of a stream of air
      6.2.6. The sensor of temperature of arriving air
      6.2.7. The sensor of temperature of cooling liquid
      6.2.8. Sensor of provision of a cranked shaft
      6.2.9. Sensor of provision of a camshaft
      6.2.10. Switch of system of hydrostrengthening of a steering
      6.2.11. Oxygen sensor
      6.2.12. Sensor of detonation combustion of fuel
      6.2.13. Sensor of speed
      6.2.14. Air valve
      6.2.15. System of additional supply of air on low turns
      6.2.16. System of ventilation of a case
      6.2.17. System of a retsirkulyatsiya of exhaust gases
      6.2.18. Collecting system паров fuels
      6.2.19. Switch of fires of a stoplight
      6.2.20. Catalytic converter
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


6.2.12. Sensor of detonation combustion of fuel

Check

PERFORMANCE ORDER
For sensor check, disconnect the socket of connection and measure resistance between the plug A and "massoy". It should make about 560 Ohm. Replace the sensor if it is necessary.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove an inlet collector and a hose of system of cooling if it is necessary. Disconnect the socket of connection and remove the sensor (shooter).
3. Installation is carried out upside-down removals.