Скорее посмотрите: подарки своими руками из конфет

Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
- 6. Exhaust system
   + 6.1. Exhaust system
   - 6.2. Systems of decrease in toxicity of exhausts and management of operation of the engine
      6.2.1. Introduction
      6.2.2. System of self-diagnostics and malfunction codes
      6.2.3. Central control unit
      6.2.4. Sensor of provision of a butterfly valve
      6.2.5. Sensor of a stream of air
      6.2.6. The sensor of temperature of arriving air
      6.2.7. The sensor of temperature of cooling liquid
      6.2.8. Sensor of provision of a cranked shaft
      6.2.9. Sensor of provision of a camshaft
      6.2.10. Switch of system of hydrostrengthening of a steering
      6.2.11. Oxygen sensor
      6.2.12. Sensor of detonation combustion of fuel
      6.2.13. Sensor of speed
      6.2.14. Air valve
      6.2.15. System of additional supply of air on low turns
      6.2.16. System of ventilation of a case
      6.2.17. System of a retsirkulyatsiya of exhaust gases
      6.2.18. Collecting system паров fuels
      6.2.19. Switch of fires of a stoplight
      6.2.20. Catalytic converter
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice



6.2.7. The sensor of temperature of cooling liquid

GENERAL INFORMATION

Arrangement of the sensor of temperature of cooling liquid (model with the 6-cylinder engine)

The sensor of temperature of cooling liquid is a termistor, i.e. its resistance decreases at sensor temperature increase.

Check, that resistance of the sensor at room temperature made about 2200-2700 Ohm. Heat up the sensor to temperature 80 ° With and check, that its resistance decreased to 290–350 Ohm. Replace the sensor if it is faulty.

Replacement

PERFORMANCE ORDER
1. Disconnect the socket of connection and accurately unscrew the sensor.
2. Installation is carried out upside-down removals.