Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Petrol engines (1,6 and 1,8 liters)
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Recommendations about repair
      3.1.4. Top dead point
      3.1.5. Cover of valves
      3.1.6. Inlet collector
      3.1.7. Final collector
      3.1.8. Gas-distributing belt and asterisks
      3.1.9. Camshaft epiploons
      3.1.10. Yokes and distributive (е) shaft (ы)
      3.1.11. Springs of valves, fastenings and laying
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Forward cover
      3.1.15. Oil pump
      3.1.16. Forward epiploon of a cranked shaft
      3.1.17. Flywheel
      3.1.18. Back epiploon of a cranked shaft
      3.1.19. Engine fastenings
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice



3.1.15. Oil pump

Removal

PERFORMANCE ORDER
1. Remove a forward cover which is a casing of the oil pump.
2. Take an epiploon of a cranked shaft from a cover.
3. Uncover the oil pump.
4. Remove the reduktsionny valve.

Check

PERFORMANCE ORDER
1. Establish gear rings in a casing of the pump and measure a gap between a leading gear ring and a pump casing.
2. Measure a gap between the leader and conducted by gear rings.
3. Measure a gap between the plane of gear rings and the plane of a casing of the pump.
4. Measure length of a spring of the reduktsionny valve, if necessary replace a spring.
5. Oil a new epiploon and establish into place.
6. Grease the piston of the reduktsionny valve with engine oil and establish the valve in a pump casing.
7. Grease gear rings and establish in a casing.
8. Establish a cover of the pump and tighten bolts.

Installation

PERFORMANCE ORDER
1. Establish a forward cover and tighten bolts.
2. Establish the remained details.