Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Petrol engines (1,6 and 1,8 liters)
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Recommendations about repair
      3.1.4. Top dead point
      3.1.5. Cover of valves
      3.1.6. Inlet collector
      3.1.7. Final collector
      3.1.8. Gas-distributing belt and asterisks
      3.1.9. Camshaft epiploons
      3.1.10. Yokes and distributive (е) shaft (ы)
      3.1.11. Springs of valves, fastenings and laying
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Forward cover
      3.1.15. Oil pump
      3.1.16. Forward epiploon of a cranked shaft
      3.1.17. Flywheel
      3.1.18. Back epiploon of a cranked shaft
      3.1.19. Engine fastenings
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


3.1.19. Engine fastenings
GENERAL INFORMATION
Prevention

During check the engine is necessary for raising slightly to transfer its weight from support on the lift.

Right support of the engine
1. Through bolt of a support

2. Dynamic damper of a support

3. Nuts of an arm of a support

Check

PERFORMANCE ORDER
1. Check rubber shock-absorbers of support on existence of cracks and damages.
2. Move support a big screw-driver if support are loosened, tighten their fastenings.

Replacement

PERFORMANCE ORDER
Support (N1 and N2) engine and transmission
1. Braid the support nuts, fixing it to a cross-piece.
2. Unscrew through bolts and remove a support from an arm.
3. Unscrew bolts of a cross-piece and remove a cross-piece.
4. Establish a new support on an arm and tighten bolts.
Right support (N3) of the engine
5. Unscrew and remove a through bolt of a support.
6. Remove a dynamic damper from a support.
7. Braid nuts of an arm of a support and remove a support.
8. Establish a new support, insert and tighten a bolt and nuts.
Left support (N4) of the engine
9. Remove the accumulator and accumulator fastening.
10. Unscrew bolts and nuts of an arm of a support.
11. Unscrew support bolts.
12. Remove a support.
13. Establish a new support.