Mazda 626
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
- 3.1. Petrol engines (1,6 and 1,8 liters)
3.1.1. Introduction
3.1.2. Technical characteristics
3.1.3. Recommendations about repair
3.1.4. Top dead point
3.1.5. Cover of valves
3.1.6. Inlet collector
3.1.7. Final collector
3.1.8. Gas-distributing belt and asterisks
3.1.9. Camshaft epiploons
3.1.10. Yokes and distributive (е) shaft (ы)
3.1.11. Springs of valves, fastenings and laying
3.1.12. Head of cylinders
3.1.13. Oil pallet
3.1.14. Forward cover
3.1.15. Oil pump
3.1.16. Forward epiploon of a cranked shaft
3.1.17. Flywheel
3.1.18. Back epiploon of a cranked shaft
3.1.19. Engine fastenings
+ 3.2. Petrol 4-cylinder engine (2 liters)
+ 3.3. Petrol V6 engine (2,5 liters)
+ 3.4. Partition of engines (1,6 and 1,8 liters)
+ 3.5. Partition of engines (2,0 and 2,5 liters of V6)
+ 3.6. Diesel engine of 2,0 liters
+ 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice
|
Removal
| PERFORMANCE ORDER |
| 1. Disconnect a wire of the minus plug of the accumulator. |
| 2. Disconnect a wire of the oxygen sensor, remove the sensor if you establish a new collector. |
|
3. Unscrew bolts of the heatisolating screen and remove the screen. |
| 4. Lift and fix a forward part of the car. |
| 5. Disconnect an exhaust pipe from a collector and lower the car. |
| 6. Unscrew bolts of a collector and remove a collector. |
|
Installation
| PERFORMANCE ORDER |
| 1. Clean being joined surfaces of a collector and a head of cylinders. If laying of a collector escaped, address to experts. |
| 2. Establish new laying. |
| 3. Establish a collector and insert bolts. |
| 4. Tighten bolts and establish the remained details. |
| 5. Check operation of the engine. |
|
|
|