Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   - 3.3. Petrol V6 engine (2,5 liters)
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Recommendations about repair
      3.3.4. Top dead point of the first piston
      3.3.5. Covers of heads of cylinders
      3.3.6. Springs, clamps and epiploons of valves
      3.3.7. Gas-distributing belt and asterisks
      3.3.8. Camshafts and pushers
      3.3.9. Inlet collector
      3.3.10. Final collectors
      3.3.11. Heads of cylinders
      3.3.12. Forward epiploon of a cranked shaft
      3.3.13. Oil pallet
      3.3.14. Oil pump
      3.3.15. Flywheel or leading disk
      3.3.16. Back epiploon of a cranked shaft
      3.3.17. Engine fastenings
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

3.3.12. Forward epiploon of a cranked shaft

GENERAL INFORMATION

There are two methods of replacement of a forward epiploon of a cranked shaft. You can remove the oil pump and beat out an epiploon (a recommended method) or to use easier method described below.

Replacement

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Stop a cranked shaft and unscrew a pulley bolt.
	3. Remove a pulley of a cranked shaft.
4. Remove a gas-distributing belt and an asterisk of a cranked shaft.
	5. Remember depth of landing of an epiploon and take it by means of the special tool or by means of a screw-driver.
6. Clean a groove of an epiploon and grease a new epiploon with engine oil.
	7. Establish a new epiploon into place.
8. Establish the remained details, get the engine and check it on existence of leaks.