Mazda 626
1991-1998 of release
Repair and car operation
Mazda 626
+
1. Maintenance instruction
+
2. Maintenance
-
3. Engines
+
3.1. Petrol engines (1,6 and 1,8 liters)
+
3.2. Petrol 4-cylinder engine (2 liters)
-
3.3. Petrol V6 engine (2,5 liters)
3.3.1. Introduction
3.3.2. Technical characteristics
3.3.3. Recommendations about repair
3.3.4. Top dead point of the first piston
3.3.5. Covers of heads of cylinders
3.3.6. Springs, clamps and epiploons of valves
3.3.7. Gas-distributing belt and asterisks
3.3.8. Camshafts and pushers
3.3.9. Inlet collector
3.3.10. Final collectors
3.3.11. Heads of cylinders
3.3.12. Forward epiploon of a cranked shaft
3.3.13. Oil pallet
3.3.14. Oil pump
3.3.15. Flywheel or leading disk
3.3.16. Back epiploon of a cranked shaft
3.3.17. Engine fastenings
+
3.4. Partition of engines (1,6 and 1,8 liters)
+
3.5. Partition of engines (2,0 and 2,5 liters of V6)
+
3.6. Diesel engine of 2,0 liters
+
3.7. Systems of electric equipment of the engine
+
4. Heating and ventilation
+
5. Fuel system
+
6. Exhaust system
+
7. Transmissions
+
8. Coupling and semi-axes
+
9. Brake system
+
10. Running gear
+
11. Body
+
12. Electric equipment
+
13. Electroschemes
+
14. Good advice
Как промыть радиатор печки без снятия
3.3.16. Back epiploon of a cranked shaft
Replacement
PERFORMANCE ORDER
1.
Remove a transmission.
2.
Remove a flywheel.
3.
Cut off an epiploon ledge a knife.
4.
Take an epiploon by means of a screw-driver or by means of the special tool.
5.
Grease a new epiploon with engine oil and hammer it into place.