Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   - 3.3. Petrol V6 engine (2,5 liters)
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Recommendations about repair
      3.3.4. Top dead point of the first piston
      3.3.5. Covers of heads of cylinders
      3.3.6. Springs, clamps and epiploons of valves
      3.3.7. Gas-distributing belt and asterisks
      3.3.8. Camshafts and pushers
      3.3.9. Inlet collector
      3.3.10. Final collectors
      3.3.11. Heads of cylinders
      3.3.12. Forward epiploon of a cranked shaft
      3.3.13. Oil pallet
      3.3.14. Oil pump
      3.3.15. Flywheel or leading disk
      3.3.16. Back epiploon of a cranked shaft
      3.3.17. Engine fastenings
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


Делаем подсветку потолочных карнизов Лазерный стимулятор

3.3.17. Engine fastenings

Check

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary replace them.
3. Check, that bolts of support were strong tightened.
4. Check, whether support are worn-out.

Replacement

PERFORMANCE ORDER
Right support
1. Unscrew a through bolt of a support (And), the top bolts, fixing a support to the engine (In). Remove a support.
2. Installation is carried out upside-down removals.
Forward support
3. The forward support is located between the engine and a radiator. Unscrew a through bolt of a forward support (And) and nuts) In), remove a support.
4. Installation is carried out upside-down removals.
Back support
Prevention

Access to this support is strongly complicated, for simplification of access you can remove an inlet collector.

6. Unscrew a through bolt, braid nuts and remove a support. Unscrew a through bolt of a support (And) and bolts of an arm of a transmission (In).
7. Installation is carried out upside-down removals.
Left support
Top support
8. The support is attached to a body and the top part of a transmission. Unscrew a through bolt (And), a bolt (In) and a nut (C), disconnect wires and braid a nut (D).
Bottom support

9. The bottom support connects a transmission to the cross-piece located under it. Braid two nuts (And) and two bolts (In).