Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   - 3.5. Partition of engines (2,0 and 2,5 liters of V6)
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Repair work without engine dismantle from the car
      + 3.5.4. Major maintenance of the engine
      3.5.5. Check by means of a vacuum measuring instrument
      3.5.6. Compression check
      3.5.7. Methods of dismantle of the engine
      3.5.8. Removal and engine installation
      3.5.9. Engine partition
      3.5.10. Partition and check of a head of cylinders
      3.5.11. Valves
      3.5.12. Assembly of a head of cylinders
      3.5.13. Removal of pistons and rods
      3.5.14. Removal of a cranked shaft
      3.5.15. Check of the block of cylinders
      3.5.16. Honingovaniye of cylinders
      3.5.17. Check of pistons and rods
      3.5.18. Check of a cranked shaft
      3.5.19. Check and selection of radical bearings and bearings of rods
      3.5.20. Check of camshafts and pushers
      3.5.21. Engine assembly order
      3.5.22. Installation of piston rings
      3.5.23. Installation of a cranked shaft
      3.5.24. Installation of a back epiploon of a cranked shaft
      3.5.25. Installation of pistons and rods
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


3.5.19. Check and selection of radical bearings and bearings of rods

GENERAL INFORMATION

Causes of wear of bearings

1. Decrease in strength of metal; fragmentary scratches
2. It is incorrectly planted; the bright (polished) strips
3. It is scratched гразью; dirt ate in a bearing surface
4. Lack of oil; the top layer was wiped
5. Excessive wear; the top layer was wiped on all surface
6. The bearing is deformed; the top layer was wiped around

In spite of the fact that at an engine partition old loose leaves of bearings are replaced on new, it is necessary to examine old loose leaves carefully. Survey of the loose leaf can establish the reason of its wear.

Damage of bearings occurs because of a lack of greasing, availability of dirt and other alien particles, an engine and corrosion overload. In any case, it is necessary to eliminate the reason of damage of bearings prior to the beginning of engine assembly.

For the correct selection of loose leaves be guided by size of a lubricant gap which it is possible to measure by means of a plastic measuring tape. At emergence of any problems with selection of loose leaves address to experts.