Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   - 3.5. Partition of engines (2,0 and 2,5 liters of V6)
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Repair work without engine dismantle from the car
      + 3.5.4. Major maintenance of the engine
      3.5.5. Check by means of a vacuum measuring instrument
      3.5.6. Compression check
      3.5.7. Methods of dismantle of the engine
      3.5.8. Removal and engine installation
      3.5.9. Engine partition
      3.5.10. Partition and check of a head of cylinders
      3.5.11. Valves
      3.5.12. Assembly of a head of cylinders
      3.5.13. Removal of pistons and rods
      3.5.14. Removal of a cranked shaft
      3.5.15. Check of the block of cylinders
      3.5.16. Honingovaniye of cylinders
      3.5.17. Check of pistons and rods
      3.5.18. Check of a cranked shaft
      3.5.19. Check and selection of radical bearings and bearings of rods
      3.5.20. Check of camshafts and pushers
      3.5.21. Engine assembly order
      3.5.22. Installation of piston rings
      3.5.23. Installation of a cranked shaft
      3.5.24. Installation of a back epiploon of a cranked shaft
      3.5.25. Installation of pistons and rods
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


3.5.22. Installation of piston rings

PERFORMANCE ORDER
1. Before installation it is necessary to check trailer and lateral gaps of piston rings.
2. Establish the top kompressionny ring in the cylinder by means of the piston.
3. Measure a trailer gap of a ring. If a gap too small, you can replace piston rings or increase a gap, having ground the ends of a piston ring a small file.
4. Carry out similar procedure with all rings.
5. After check and adjustment of a trailer gap, a ring it is possible to establish on pistons.
6. The maslosjemny ring is established to the first. At first establish a broad ring in a flute, then establish the bottom and top maslosjemny rings.
7. After installation of all elements of a maslosjemny ring check, that the top and bottom rings rotated freely.
8. Establish the second kompressionny ring by means of the special tool a mark up.
9. Then establish the top kompressionny ring.
10. Do similar procedures with remained pistons.