Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   - 3.5. Partition of engines (2,0 and 2,5 liters of V6)
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Repair work without engine dismantle from the car
      + 3.5.4. Major maintenance of the engine
      3.5.5. Check by means of a vacuum measuring instrument
      3.5.6. Compression check
      3.5.7. Methods of dismantle of the engine
      3.5.8. Removal and engine installation
      3.5.9. Engine partition
      3.5.10. Partition and check of a head of cylinders
      3.5.11. Valves
      3.5.12. Assembly of a head of cylinders
      3.5.13. Removal of pistons and rods
      3.5.14. Removal of a cranked shaft
      3.5.15. Check of the block of cylinders
      3.5.16. Honingovaniye of cylinders
      3.5.17. Check of pistons and rods
      3.5.18. Check of a cranked shaft
      3.5.19. Check and selection of radical bearings and bearings of rods
      3.5.20. Check of camshafts and pushers
      3.5.21. Engine assembly order
      3.5.22. Installation of piston rings
      3.5.23. Installation of a cranked shaft
      3.5.24. Installation of a back epiploon of a cranked shaft
      3.5.25. Installation of pistons and rods
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice



3.5.13. Removal of pistons and rods

PERFORMANCE ORDER
1. In 4-cylinder engines remove strengthening section of the engine (cм. subsection 3.2.14).
2. By means of the special tool remove a ledge in the top part of the cylinder, formed as a result of wear and deposits of products of combustion. Do not try to get the piston, without having removed a ledge, differently you damage the piston.
3. Overturn the engine, cranked shaft up.
4. With the help щупов measure a lateral gap of rods. If the gap exceeds admissible limits, it is necessary to replace a rod. At the emergence, any doubts, address to experts.
5. If rods and covers of rods are not numbered, number them.
6. Weaken nuts of everyone of rod covers in stages on a turn floor. Braid nuts, and uncover the first rod and the bearing loose leaf.
7. Remove the loose leaf of the bearing and get a rod together with the piston.
8. Remove other rods and pistons similarly.
9. Combine elements of each of pistons separately not to mix them.