Mazda 626
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
- 9. Brake system
9.1. Introduction
9.2. Technical characteristics
9.3. System of anti-blocking of brakes (ABS)
9.4. Brake overlays of disk brakes
9.5. Brake support
9.6. Brake disk
9.7. Brake shoes of drum-type brakes
9.8. Wheel cylinder
9.9. Main brake cylinder
9.10. Brake tubes and hoses
9.11. Pumping of brake system
9.12. Vacuum amplifier
9.13. Height and free wheeling of a pedal of a brake
9.14. Hand brake
9.15. Ropes of the hand brake
9.16. Switch of an alarm bulb of low level of brake liquid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice
|
Check
| PERFORMANCE ORDER |
| Work check |
| 1. Squeeze out a pedal and start the engine. If the pedal fell a little, means, the vacuum amplifier is serviceable. |
| 2. Squeeze out a brake pedal several times at the switched-on engine and check, that the reserve of a course of a pedal of a brake always was same. |
| Tightness check |
| 3. Start the engine and muffle it in few minutes. Slowly squeeze out a brake pedal several times. The course of a pedal of a brake should decrease each time. |
| 4. Squeeze out a brake pedal at the working engine, then muffle the engine, without releasing a brake pedal. If the pedal does not fall within 30 seconds, means, the vacuum amplifier is tight. |
|
Removal
| PERFORMANCE ORDER |
| 1. Remove the main brake cylinder. Disconnect a vacuum hose from the amplifier. |
| 2. Disconnect a pusher of the amplifier from a brake pedal. |
|
3. Turn off four fixing nuts and remove the amplifier. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down removals. |
| 2. Connect the vacuum pump to the amplifier and create depression in 500 mm of a mercury column. |
|
3. Measure distance from a surface of the vacuum amplifier to a pusher is a distance "And". |
|
4. Measure distance from a fixing flange till the end of the main cylinder is a distance of "B". |
|
5. Measure distance from the end of the main cylinder before deepening in the piston is a distance "In". |
| 6. Subtract value "V" from value "B", subtract the received value from value "A". The received result is value of a gap of a pusher of a servoamplifier. |
|
7. Adjust length of a pusher (1) if it is necessary, having weakened a lock-nut (2) and having tightened up a pusher regulator. |
|
|
|