Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
- 9. Brake system
   9.1. Introduction
   9.2. Technical characteristics
   9.3. System of anti-blocking of brakes (ABS)
   9.4. Brake overlays of disk brakes
   9.5. Brake support
   9.6. Brake disk
   9.7. Brake shoes of drum-type brakes
   9.8. Wheel cylinder
   9.9. Main brake cylinder
   9.10. Brake tubes and hoses
   9.11. Pumping of brake system
   9.12. Vacuum amplifier
   9.13. Height and free wheeling of a pedal of a brake
   9.14. Hand brake
   9.15. Ropes of the hand brake
   9.16. Switch of an alarm bulb of low level of brake liquid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice



9.9. Main brake cylinder

Removal

PERFORMANCE ORDER
1. Disconnect a rope of a drive of system cruise control if it is necessary.
2. On models with a mechanical transmission disconnect a hose of a hydraulic drive of switching off of coupling from a tank of brake liquid.
3. Pump out brake liquid from a tank.
4. Turn off fixing nuts and disconnect brake tubes from the cylinder.
5. Disconnect the socket of connection of the fuel level sensor from a tank, turn off fixing nuts and remove the cylinder from the vacuum amplifier.

Installation

Installation is carried out upside-down removals.

Before installation of the cylinder remove from it air.