Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
- 9. Brake system
   9.1. Introduction
   9.2. Technical characteristics
   9.3. System of anti-blocking of brakes (ABS)
   9.4. Brake overlays of disk brakes
   9.5. Brake support
   9.6. Brake disk
   9.7. Brake shoes of drum-type brakes
   9.8. Wheel cylinder
   9.9. Main brake cylinder
   9.10. Brake tubes and hoses
   9.11. Pumping of brake system
   9.12. Vacuum amplifier
   9.13. Height and free wheeling of a pedal of a brake
   9.14. Hand brake
   9.15. Ropes of the hand brake
   9.16. Switch of an alarm bulb of low level of brake liquid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

9.6. Brake disk


1. Remove a brake support.
2. Examine a disk surface on existence of scratches or damages. If depth of scratches exceeds 0,3 mm, the surface of a disk is necessary for restoring.
3. Check disk palpation by means of the tsiferblatny sensor.
4. If a disk as it should be, process a disk surface an emery paper.
5. Check thickness of a disk and distinction in thickness of a disk between various sites. Replace a brake disk if it is necessary.


Minimum admissible thickness of a brake disk is usually specified on the disk.


1. Before removal of a brake disk of a forward wheel turn off fixing bolts (are specified by shooters).
2. Remove a fixing arm of a support.
3. If fixing bolts of a brake disk are not turned off, use a special screw-driver.
4. If the brake disk does not act in film, twirl two bolts in specially provided openings and tighten them to remove a brake disk.


Installation is carried out upside-down removals.