Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
- 9. Brake system
   9.1. Introduction
   9.2. Technical characteristics
   9.3. System of anti-blocking of brakes (ABS)
   9.4. Brake overlays of disk brakes
   9.5. Brake support
   9.6. Brake disk
   9.7. Brake shoes of drum-type brakes
   9.8. Wheel cylinder
   9.9. Main brake cylinder
   9.10. Brake tubes and hoses
   9.11. Pumping of brake system
   9.12. Vacuum amplifier
   9.13. Height and free wheeling of a pedal of a brake
   9.14. Hand brake
   9.15. Ropes of the hand brake
   9.16. Switch of an alarm bulb of low level of brake liquid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


На теле гусиная кожа как избавиться в домашних условиях

9.7. Brake shoes of drum-type brakes
GENERAL INFORMATION
Prevention

Always replace brake shoes at the same time on both wheels. Observe precautionary measures at work with the brake dust containing asbestos which is hazardous to health.

Elements of a drum-type brake

 1. Clamping spring

2. Forward brake shoe

3. Regulator

4. Regulator of the hand brake

5. Returnable spring

6. Lever manual томоза

7. Back brake shoe

8. Rope of the hand brake

9. Returnable spring

Replacement

PERFORMANCE ORDER
1. Remove back wheels.
2. Remove a brake drum. If he does not act in film, twirl a bolt in diameter of 8 mm in the provided opening to wring out a drum.
3. Turn off a fixing nut and remove a nave of a back wheel.
4. Clear the brake mechanism of a dust and dirt.
5. Press on a clamping spring, turn a pin and remove a spring.
6. Disconnect the top returnable spring from a forward brake shoe.
7. Disconnect a regulator and the bottom returnable spring from a forward brake shoe.
8. Remove a clamping spring of a back brake shoe.
9. Remove a back brake shoe and disconnect a returnable spring.
10. Disconnect a regulator spring from a block.
11. Remove pins of clamping springs.
12. Remove a rope of the hand brake from the lever on a back brake shoe.
13. Grease installation sites of brake shoes with high-temperature greasing.
14. Release a fixing clip by means of a screw-driver.
15. Establish the lever of the hand brake on a new block.
16. Establish into place pins of clamping springs.
17. Connect a rope of the hand brake to the lever.
18. Connect a returnable spring to a back brake shoe.
19. Establish a back tomozny block on a brake guard.
20. Establish a clip on a pin of a clamping spring.
21. Connect the bottom returnable spring in a back brake shoe.
22. Establish a forward brake shoe into place, connect the bottom returnable spring and establish a clamping spring.
23. Connect the top returnable spring to a forward brake shoe.
24. Tighten up a regulator of the hand brake to reduce distance between brake shoes before installation of a brake drum.
25. Examine a brake drum on existence of cracks, scratches and wear tracks. Check diameter of a brake drum.

26. Installation is carried out upside-down removals.