Mazda 626

1991-1998 of release

Repair and car operation


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
- 9. Brake system
   9.1. Introduction
   9.2. Technical characteristics
   9.3. System of anti-blocking of brakes (ABS)
   9.4. Brake overlays of disk brakes
   9.5. Brake support
   9.6. Brake disk
   9.7. Brake shoes of drum-type brakes
   9.8. Wheel cylinder
   9.9. Main brake cylinder
   9.10. Brake tubes and hoses
   9.11. Pumping of brake system
   9.12. Vacuum amplifier
   9.13. Height and free wheeling of a pedal of a brake
   9.14. Hand brake
   9.15. Ropes of the hand brake
   9.16. Switch of an alarm bulb of low level of brake liquid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


9.4. Brake overlays of disk brakes
GENERAL INFORMATION
Prevention

Always replace brake slips at the same time on both wheels. Observe precautionary measures at work with the brake dust containing asbestos which is hazardous to health.

Replacement

FORWARD WHEELS

PERFORMANCE ORDER
1. Remove a tank cap with brake liquid. Remove a wheel. Examine a brake disk on existence of wear or damages.
2. Press the piston deep into a support by means of a clamp.
3. Clear the brake mechanism of a dust and dirt.
4. Turn off a fixing bolt of a support (it is specified by an arrow; the top arrow specified a bolt of connection of a banjo of a brake hose).
5. Lift a support (at the left) and fix a support in this situation by means of a wire piece (on the right).
6. Remove antinoise springs.
7. Remove an external brake slip.
8. Remove an internal brake slip.
9. Remove fixing clips of brake slips.
10. Replace fixing clips if they are leaky established on a fixing arm of a support.
11. Put antinoise greasing on a reverse side of brake slips.
12. Establish a new internal brake slip.
13. Establish a new external brake slip.
14. Establish into place antinoise springs.
15. Clear a finger of a support and grease it with high-temperature greasing.
16. Establish a support on a brake disk and slips.
17. Establish a fixing bolt and tighten it till the demanded moment of an inhaling.

BACK WHEELS

PERFORMANCE ORDER
1. Remove a tank cap with brake liquid. Remove a wheel. Examine a brake disk on existence of wear or damages.
2. Remove a clip from a rope of the hand brake.
3. Turn off an adjusting nut of a rope of the hand brake.
4. Disconnect a rope from the lever.
5. Turn off a bolt (at the left) and tighten up an adjusting gear wheel counter-clockwise to clean the piston deep into a support (on the right).
6. Turn off a fixing bolt of a support.
7. Remove a support from a brake disk.
8. Remove antinoise springs.
9. Remove an external brake slip.
10. Remove an internal brake slip.
11. Remove fastenings of brake slips.
12. Before installation of brake slips put on their reverse side antinoise greasing.
13. Installation is carried out upside-down removals.

LOBBIES AND BACK WHEELS

 Establish wheels and lower the car on the earth. Check level of hydraulic liquid in a tank of brake system and work of brake system.