Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristics
   2.2. Schedule of maintenance of Ford Probe, Mazda 626 and MX-6
   2.3. Primary and secondary checks
   2.4. Check of level of oil and liquids
   2.5. Check of a condition of tires and pressure in tires
   2.6. Check of level of liquid of system of hydrostrengthening of a steering
   2.7. Check of level of AKPP liquid
   2.8. Replacement of engine oil and oil filter
   2.9. Check of seat belts
   2.10. Survey and replacement of brushes of screen wipers
   2.11. Check, maintenance and battery charging
   2.12. Check, adjustment of a tension and replacement of a driving belt
   2.13. Check and replacement of hoses in an impellent compartment
   2.14. Check of system of cooling
   2.15. Shift of wheels
   2.16. Check of brake system
   2.17. Check of level of oil of a mechanical transmission
   2.18. Replacement of the air filter
   2.19. Check and replacement of spark plugs
   2.20. Check and replacement of elements of system of ignition
   2.21. Check and replacement of the valve of ventilation of a case
   2.22. Check and adjustment of speed of idling (model till 1997 of century)
   2.23. Check and adjustment of a corner of an advancing of ignition (model till 1997 of century)
   2.24. Replacement of cooling liquid and washing of system of cooling
   2.25. Replacement of brake liquid
   2.26. Steering and suspension bracket check
   2.27. AKPP liquid replacement
   2.28. Replacement of oil of a mechanical transmission
   2.29. Check of an exhaust system
   2.30. Power supply system check
   2.31. Check and adjustment of gaps of valves (model of 1998 of release)
   2.32. Replacement of the fuel filter
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

2.23. Check and adjustment of a corner of an advancing of ignition (model till 1997 of century)

GENERAL INFORMATION

Tools necessary for check and adjustment of a corner of an advancing of ignition

1. Caps

2. Stroboscope

3. A key for untwisting of a fixing bolt of the distributor of ignition

PERFORMANCE ORDER

1. Warm up the engine to normal working temperature.
2. Prepare the tools necessary for check of a corner of an advancing of ignition.
3. Connect a stroboscope.
4. On the Ford Probe models remove a crossing point from the socket of connection of SPOUT located between the accumulator and the diagnostic socket of connection. Connect TEN and GND plugs of the diagnostic socket of connection.
5. Start the engine and direct a stroboscope beam on an adjusting ruler and a yellow mark in a pulley of a cranked shaft. If the yellow mark does not coincide with the necessary mark in an adjusting ruler, turn off a fixing bolt of the distributor of ignition and turn the distributor as it is necessary.
6. Tighten a fixing bolt and again check a corner of an advancing of ignition.