Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristics
   2.2. Schedule of maintenance of Ford Probe, Mazda 626 and MX-6
   2.3. Primary and secondary checks
   2.4. Check of level of oil and liquids
   2.5. Check of a condition of tires and pressure in tires
   2.6. Check of level of liquid of system of hydrostrengthening of a steering
   2.7. Check of level of AKPP liquid
   2.8. Replacement of engine oil and oil filter
   2.9. Check of seat belts
   2.10. Survey and replacement of brushes of screen wipers
   2.11. Check, maintenance and battery charging
   2.12. Check, adjustment of a tension and replacement of a driving belt
   2.13. Check and replacement of hoses in an impellent compartment
   2.14. Check of system of cooling
   2.15. Shift of wheels
   2.16. Check of brake system
   2.17. Check of level of oil of a mechanical transmission
   2.18. Replacement of the air filter
   2.19. Check and replacement of spark plugs
   2.20. Check and replacement of elements of system of ignition
   2.21. Check and replacement of the valve of ventilation of a case
   2.22. Check and adjustment of speed of idling (model till 1997 of century)
   2.23. Check and adjustment of a corner of an advancing of ignition (model till 1997 of century)
   2.24. Replacement of cooling liquid and washing of system of cooling
   2.25. Replacement of brake liquid
   2.26. Steering and suspension bracket check
   2.27. AKPP liquid replacement
   2.28. Replacement of oil of a mechanical transmission
   2.29. Check of an exhaust system
   2.30. Power supply system check
   2.31. Check and adjustment of gaps of valves (model of 1998 of release)
   2.32. Replacement of the fuel filter
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice



2.8. Replacement of engine oil and oil filter

GENERAL INFORMATION

Tools necessary for replacement of the oil filter

1. Pallet

2. Rubber gloves

3. Handle

4. Nozzle

5. A special key for filter untwisting

6. A key for filter untwisting

PERFORMANCE ORDER
1. Before the beginning of work prepare necessary tools and materials.
2. Warm up the engine. Remove a cap of a jellied mouth of oil.
3. Lift the car and establish it on support.
4. Establish the pallet under a drain opening of oil and turn off a cap by means of a cap wrench. Wait, while oil will flow down. Wipe a cap and establish it into place.
5. Establish the pallet under the oil filter and unscrew the filter, rotating it counter-clockwise. For untwisting of the oil filter use a special key.
6. Wipe the block of cylinders and an opening for filter installation.
7. Grease rubber laying of the new filter by engine oil and twirl the filter into place. Twist the filter a hand while laying of the filter will not concern the block of cylinders. Then turn the filter in addition on 3/4 turns.
8. Fill in new engine oil through a jellied mouth. Wait, while oil will flow down in the pallet. Start the engine and check, whether there is no leak. Check level of oil and add it if it is necessary.